Ceiling planks – to do it, please turn off the electricity to the room. Locate the ceiling joists. Scoring their location. Installing planks perpendicular to the joists. Measure 1/4-inch from the wall on the ceiling at different points. Connect the signs along the ceiling. Put a construction panel serpentine along the back drop of glue on one axle of the wooden ceiling. Set the plank along the expansion gap line with the groove towards the wall. Pull the board a bit ‘away from the ceiling and press firmly into place. Pulling out and restore it.
Fix the table to the ceiling with finish nails embedded in the joists. Use the chalk lines as a guide to nail placement. Put two nails at each joist location on both sides of the dashboard. Set the nails slightly below the surface with a nail September. Apply adhesive to the next table. Slide fasteners tongue and groove on the ends of the bridge and the first firmly together. Press the ceiling planks. Continue to the end of the first line. Cut the last board to fit with a circular saw. Attach with adhesive and nails.
The second row with the remaining part of the board is cut in the previous step. Apply glue to the plank. Press the tab on the front row of the plank in the groove of the second row table. Secure the board. Continue to set up tables for this line in place. Stagger the joints of the previous line so they do not line up. Measure and cut the wood molding to walk around the perimeter of the room. Fill the nail holes with wood putty. Reconnect the ceiling light or fan. The ceiling planks were perfect now.